Draft Bench
Fix non-coplanar FILLET lines in AutoCAD LT

Open Practice-before.dwg in Model space. We tested this exercise with
AutoCAD LT 2027 for Windows. Both drawings use the DWG 2018 file format.
The exercise uses drawing units. The cyan line lies at Z=0 and both
endpoints of the yellow line are at Z=12 in the World UCS.

1. Run FILLET, choose Radius, and enter 0. Select the two lines.
   AutoCAD reports "Lines are non coplanar."
2. Select the yellow line, press Ctrl+1, and check Start Z and End Z
   under Geometry. Both should read 12. Deselect the line.
3. Run CHANGE, select the yellow line, and press Enter. Choose
   Properties, then Elevation, enter 0, and press Enter to finish.
4. Run FILLET again at radius 0 and pick the two lines. In this drawing
   they now meet at (100, 0, 0). Compare with Practice-after.dwg.

Use this elevation change for a line whose endpoints share the same
incorrect Z when the intended plane is Z=0.
